honda — Programmed Fuel Injection

BF135A•BF150A 8) Apply a thin coat of the engine oil to a new cover gasket and install it on the water jacket cover. [1] COVER GASKET Do not reuse. [2] WATER JACKET COVER 9) Set the eight collars on the water jacket cover and install the water jacket cover on the vapor separator chamber. [3] 5 mm COLLAR (8) 10) Set the eight 5 mm washers and the eight 5 mm screw- washers, then tighten the screws to the specified torque. TORQUE: 3.4 N m (0.35 kgf m, 2.5 lbf ft) 11) Connect the 7 x 400 mm water tube to the upper tube joint of the water jacket cover, and secure the connection of the tube with the tube clip.

12) Connect the 7.3 x 350 mm water tube to the lower tube joint of the water jacket cover, and secure the connection of the tube with the tube clip B12. [6] TUBE CLIP [7] TUBE CLIP B12 [9] 7.3 x 350 mm WATER TUBE [5] 5 mm WASHER (8) [8] 7 x 400 mm WATER TUBE [4] 5 mm SCREW- WASHER (8) 5-120