honda — Programmed Fuel Injection

BF135A•BF150A 1) Apply a thin coat of the engine oil to the new O-rings and set them on the vapor separator chamber. [1] O-RING (2) Do not reuse. 2) Install the pump case with care not to allow the O-rings to come out of position. 3) Tighten the 6 x 25 mm flange bolts. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) 6 x 25 (4) [2] FUEL PUMP CASE 4) Apply a thin coat of the engine oil to the new O-ring and set it on the pump holder. [1] PUMP HOLDER 5) Install the pump holder on the pump case. Be sure to install it in the direction shown. 6) Install the high pressure side fuel pump on the pump case. Install by aligning the projection on the pump with the hole in the pump holder.

[1] HIGH PRESSURE SIDE FUEL PUMP [2] PUMP HOLDER 5-122