honda — Programmed Fuel Injection

BF135A•BF150A 16. EOP (ENGINE OIL PRESSURE) SWITCH (HIGH PRESSURE SIDE) a. INSPECTION 1) Disconnect the high pressure side EOP switch 2P connec- tor. 2) Check for the continuity between the switch side 2P connec- tor terminals. The high pressure side EOP switch is normal if there is continuity. Replace the high pressure side EOP switch if there is no continuity. [1] EOP SWITCH 2P CONNECTOR [1] 13 x 1.5 mm O-RING b. REPLACEMENT Do not reuse. 1) Disconnect the high pressure side EOP switch 2P connec- tor. 2) Remove the EOP switch and the O-ring. Replace the O-ring on assembly. 3) Apply the engine oil to the new O-ring and install it on the switch.

[3] EOP SWITCH [2] EOP SWITCH 2P CONNECTOR 4) Tighten the EOP switch to the specified torque. TORQUE: 22 N m (2.2 kgf m, 16 lbf ft) 5) After installation, connect the switch connector. 17. EOP (ENGINE OIL PRESSURE) SWITCH (LOW PRESSURE SIDE) a. INSPECTION 1) Disconnect the low pressure side EOP switch terminal. 2) Check for the continuity between the switch terminal and the engine ground. The low pressure side EOP switch is normal if there is continuity. Replace the low pressure side EOP switch if there is no continuity. [1] EOP SWITCH 5-146