honda — Programmed Fuel Injection

BF135A•BF150A 23. CKP (CRANKSHAFT POSITION) SENSOR [1] O-RING Do not reuse. a. REPLACEMENT 1) Remove the silencer case (P. 5-128). 2) Disconnect the CKP sensor 3P connector. 3) Remove the 6 x 16 mm flange bolt, and remove the CKP sensor and the O-ring. Replace the O-ring on assembly. [2] CKP SENSOR [3] CKP SENSOR 3P CONNECTOR 6 x 16 4) Apply the engine oil to the new O-ring and install it on the CKP sensor. 5) Tighten the 6 x 16 mm flange bolt securely. 6) After installing the CKP sensor, connect the CKP sensor 3P connector. 7) Install the removed parts in the reverse order of removal. 24. VTEC SOLENOID VALVE (BF150A Only) [1] VTEC SOLENOID VALVE 1P CONNECTOR a.

REPLACEMENT [2] HARNESS BAND CLIP BRACKET C 1) Disconnect the VTEC solenoid valve 1P connector and dis- connect the connector from the harness band clip bracket C. 2) Remove the three 6 x 55 mm flange bolts. Remove the VTEC solenoid valve assembly, gasket and the filter. Replace the gasket and filter as an assembly of the VTEC solenoid valve assembly. [3] FILTER Do not reuse. 3) Install the new gasket and filter on the VTEC solenoid valve. [5] GASKET Do not reuse. 4) Install the VTEC solenoid valve assembly and tighten the 6 x 55 mm flange bolts securely. 5) Connect the VTEC solenoid valve 3P connector and set it on the harness band clip bracket C.

[4] VTEC SOLENOID VALVE ASSEMBLY 6 x 16 5-150