honda — Programmed Fuel Injection

BF135A•BF150A 20. BARO (BAROMETRIC PRESSURE) SENSOR [1] 5 x 18 mm WASHER BOLT [2] BARO SENSOR 3P CONNECTOR a. REPLACEMENT 1) Disconnect the BARO sensor 3P connector. 2) Remove the 5 x 18 mm washer bolt and remove the BARO sensor. [3] BARO SENSOR 3) Install the BARO sensor and tighten the 5 x 18 mm washer bolt securely. 4) After installation, connect the BARO sensor 3P connector. 21. KNOCK SENSOR [1] KNOCK SENSOR a. REPLACEMENT 1) Disconnect the knock sensor 1P connector. 2) Remove the knock sensor. 3) Tighten the knock sensor to the specified torque. TORQUE: 31 N m (3.1 kgf m, 22 lbf ft) 4) After installation, connect the knock sensor 1P connector. [2] KNOCK SENSOR 1P CONNECTOR 22.

CMP (CAMSHAFT POSITION) SENSOR [1] 15.2 x 1.9 mm O-RING Do not reuse. a. REPLACEMENT 1) Remove the R./L. side covers. 2) Disconnect the CMP sensor 3P connector. 3) Remove the 6 x 16 mm flange bolt and remove the CMP sensor and the O-ring. Replace the O-ring on assembly. 4) Apply the engine oil to the new O-ring and install it on the CMP sensor. 5) Tighten the 6 x 16 mm flange bolt. 6) After installation, connect the CMP sensor 3P connector. 7) Install the removed parts in the reverse order of removal. [2] CMP SENSOR [3] CMP SENSOR 3P CONNECTOR 6 x 16 5-149