BF135A•BF150A 19. ECT (ENGINE COOLANT TEMPERATURE) SENSOR 2, 3, 4 [1] ECT SENSOR 2 2P CONNECTOR [2] O-RING Do not reuse. a. REPLACEMENT 1) Disconnect the ECT sensor 2P connector. 2) Remove the ECT sensor and the O-ring. Replace the O-ring with a new one on assembly. 3) Apply the engine oil to the new O-ring and install it on the ECT sensor. 4) Tighten the overheat sensor to the specified torque. TORQUE: 12 N m (1.2 kgf m, 9 lbf ft) [3] ECT SENSOR 2 [4] ECT SENSOR 3 2P CONNECTOR OF 5) After installation, connect the ECT sensor 2P connector. [2] O-RING Do not reuse. [5] ECT SENSOR 3 [2] O-RING Do not reuse. [7] ECT SENSOR 4 2P CONNECTOR [6] ECT SENSOR 4 5-148