honda — Alternator

e. INSTALLATION 6 x 25 (4) [1] 6 mm WASHER (4) [2] SILENCER DUCT ASSEMBLY 1) Install the silencer duct assembly on the silencer case. 2) Set the four 6 mm washers and the four 6 x 25 mm flange bolts, then tighten the four 6 x 25 mm flange bolts securely. 3) Set the breather tube in the 18.5 mm clamp and the guide of the silencer duct assembly. [2] SILENCER DUCT ASSEMBLY [3] 18.5 mm CLAMP 4) Secure the pressure regulator control tube with the two 3.5 mm tube clips of the silencer duct assembly. Connect the pressure regulator control tube aligning the marked part on the tube with the end of the 3.5 mm tube clip (P. 2-71).

[1] BREATHER TUBE [4] PRESSURE REGULATOR CONTROL TUBE 5) Install the main wire harness’ harness band clip on the silencer duct assembly. 6) Install the engine cover (P. 4-2). [8] GUIDE [5] MAIN WIRE HARNESS [7] 3.5 mm TUBE CLIP (2) [6] HARNESS BAND CLIP 6-4