2. ALTERNATOR a. ALTERNATOR ASSEMBLY INSPECTION (With the alternator assembly mounted on the outboard motor) NOTICE Do not disconnect the battery terminals while the alternator is running. Alternator assembly inspection must be made with the assembly mounted on the outboard motor. Replace the IC regulator when the battery voltage exceeds 16V. Before disconnecting the alternator fuse cable, be sure to disconnect the battery negative (-) terminal. Check the following before starting the alternator assembly inspection. [1] ALTERNATOR INDICATOR LIGHT – Battery condition and cable connection – Alternator belt for looseness, cut and/or fraying (P.
3-28) – Alternator 4P connector and alternator fuse cable for connection – Blown 90A fuse and 10A fuse [1] ALTERNATOR 4P CONNECTOR – Open or short circuit in each harness and cable 1) Turn the ignition switch to the “ON” position and check that the alternator indictor light comes ON. 2) If the alternator indicator light does not come ON, disconnect the alternator 4P connector and short-circuit the white/blue terminal of the harness side connector to the ground. 3) If the indicator light still does not come ON, check the following. [2] ALTERNATOR – Indicator light (P. 16-9) – Main wire harness for open circuit 4) Start the engine and check that the alternator indicator light goes OFF.
[2] (White/ Blue) – The alternator is normal when the light goes OFF. – If the indicator light is still ON, check each part of the alternator (P. 6-14) and repeat the above steps 2 and 3. When the alert system functions while the alternator is in operation, the warning buzzer sounds intermittently. [3] Harness side connector viewed from front side 6-5 [1] ALTERNATOR 4P CONNECTOR