• RECTIFIER ASSEMBLY Inspect the rectifier assembly by removing it from the outboard motor. [1] E (GROUND) P' 1 B Check for continuity between the B terminal and the respective P terminals (P 1 , P 2 , P 3 and P 4 ), and between the E terminal and the respective P terminals (P 1 , P 2 , P 3 and P 4 ). Note to check for continuity in two directions by reversing the polarities. P 4 P 1 There should be continuity only in one direction. Replace the rectifier assembly as necessary. P 3 P 2 [2] Circuit diagram: P' 1 B P 1 P 2 P 3 P 4 [1] E (GROUND) • ROTOR 1) Check to be sure that there is continuity between the slip rings.
[2] ROTOR SHAFT [1] SLIP RINGS 2) Check to see that there is no continuity between a slip ring and the rotor, and between a slip ring and the rotor shaft. 3) Measure the slip ring O.D. [3] ROTOR 4) If the measurement is less than the service limit, replace the rotor. 6-14 f. INSPECTION (Unit inspection) • BRUSH HOLDER ASSEMBLY Measure the brush length. If the measurement is less than the service limit, replace the brush holder assembly. STANDARD SERVICE LIMIT 10.5 mm (0.41 in) 8.4 mm (0.33 in) STANDARD SERVICE LIMIT 14.4 mm (0.57 in) 14.0 mm (0.55 in)