h. ALTERNATOR ASSEMBLY ASSEMBLY 1) Tighten the two stud bolts on the stator. 2) Apply grease to the outer surface of a new front bearing. [1] DRIVER 07749-0010000 Drive the front bearing into the stator using the special tools as shown. TOOLS: Driver 07749-0010000 Attachment, 37 x 40 mm 07746-0010200 Pilot, 15 mm 07746-0040300 [3] ATTACHMENT, 37 x 40 mm 07746-0010200 [2] PILOT, 15 mm 07746-0040300 3) Install the retainer plate with the projections toward the front bearing and tighten it with the four screws. [1] RETAINER PLATE [2] SCREW (4) [3] STATOR [DRIVE END HOUSING] [5] PROJECTIONS [4] STUD BOLTS (2) 6-17