honda — Alternator

4) Tighten the special adjusting bolt. [1] 8 mm FLANGE NUT Inspect and adjust the alternator belt (P. 3-29). 10 x 80 5) After adjustment, tighten the 8 mm flange nut and 10 x 80 mm flange bolt in this order to the specified torque. TORQUE: 8 mm flange nut: 26 N . m (2.7 kgf . m, 20 lbf . ft) 10 x 80 mm flange bolt: 44 N . m (4.5 kgf . m, 33lbf . ft) 6) After tightening the nut and the bolt to the specified torque, check the alternator belt tension and deflection (P. 3-29). [2] SPECIAL ADJUSTING BOLT [3] ALTERNATOR ASSEMBLY 7) Connect the alternator 4P connector to the alternator assembly.

[1] ALTERNATOR 4P CONNECTOR 8) Connect the alternator fuse cable to the alternator assembly and loosely tighten the alternator B terminal washer-nut. 9) Tighten the alternator B terminal washer-nut to the specified torque so that the alternator fuse cable is connected at 60˚ from the horizontal line as shown. TORQUE: 8 N . m (0.8 kgf . m, 5.8 lbf . ft) 10) Install the following parts. – Silencer duct (P. 6-4) – Engine cover (P. 4-2) [3] ALTERNATOR FUSE CABLE [2] ALTERNATOR B TERMINAL WASHER-NUT [2] ALTERNATOR B TERMINAL WASHER-NUT 60° [3] ALTERNATOR FUSE CABLE 6-24