honda — Engine Removal/Installation

2. INSTALLATION [1] SHIFT SHAFT B 1) Align the punch mark on the shift shaft A with the punch mark on the shift shaft B before installing the engine assembly. [2] ALIGNMENT MARKS NOTICE Be sure to align the punch marks securely before installing the engine assembly. Install the engine assembly with care not to let the punch marks come out of alignment. Note that the proper shifting cannot be made unless the punch marks are in proper alignment. [3] SHIFT SHAFT A 2) Disconnect the water relief tube B and the 7 x 40 mm tube from the exhaust guide (P. 8-5, 6). [1] EXHAUST GUIDE 3) Remove the exhaust guide from the exhaust manifold of the engine assembly.

4) Apply grease to the exhaust manifold of the engine assembly and to the sealing surface of the exhaust guide. 5) Install the exhaust guide gasket and the exhaust guide on the mounting case, and loosely tightem the four 8 x 30 mm flange bolts. 8 x 30 (4) [2] EXHAUST GUIDE GASKET 6) Install the 10 x 16 mm dowel pin, 14 x 20 mm dowel pin, mounting case gasket and the oil pump rubber on the mounting case. [2] 10 x 55 STUD BOLTS [1] SHIFT SHAFT B 7) Lower the engine assembly slowly while aligning the two 10 x 55 mm stud bolts and the shift shaft B with the respective installation holes in the engine assembly.

NOTICE Take care not to ruin the stepped part of the shift shaft B and the threaded part of the 10 x 55 mm stud bolts. Do not allow the alignment marks on the shift shaft A and B come out of alignment. If they came out of alignment, perform the Shift Shaft A/B Alignment procedure explained for engine installation (P. 17-22). Lower the engine assembly slowly while holding the engine vertically. 7-6