8) Lower the engine assembly slowly onto the mounting case while aliging the exhaust manifold of the engine assembly with the exhaust guide. [1] EXHAUST MANIFOLD 9) Connect the water relief tube B and the 7 x 40 mm tube, disconnected in step 2, to the exhaut guide (P. 8-7, 9). NOTICE Lower the engine assembly onto the mounting case slowly while holding the engine vertically. [2] EXAUST GUIDE 10) Tighten the four 8 x 30 mm flange bolts in the numbered sequence in two or three steps from the underside of the mounting case. Tighten to the specified torque. TORQUE: 26 N . m (2.7 kgf . m, 20 lbf .
ft) ④ ② ③ ① 11) Loosely tighten each bolt and washer at the designated places from the underside of the mounting case. Then, tighten them to the specified torque in the numbered sequence in two or three steps. TORQUE: 12 x 70 mm hex. bolt, 12 x 130 mm hex. bolt: 64 N . m (6.5 kgf . m, 47 lbf . ft) 10 x 80 mm flange bolt, 10 x 110 mm flange bolt: 44 N . m (4.5 kgf . m, 33 lbf . ft) 8 x 100 mm flange bolt: 26 N . m (2.7 kgf . m, 20 lbf . ft) ① ② ④ ⑦ ⑤ ⑥ ③ 7-7 Tightening point Part name Q' ty ①, ② 12 x 130 mm hex. bolt, 12 mm washer 2 ③ 12 x 70 mm hex. bolt, 12 mm washer 1 ④, ⑤ 10 x 110 mm flange bolt 2 ⑥ 10 x 80 mm flange bolt 1 ⑦ 8 x 100 mm flange bolt 1