honda — Thermostat/Relief Valve/Flush Valve

d. ASSEMBLY 1) Check the thermostats for the identification mark and install each of them in the proper position (P. 8-3). Install the thermostat for the cylinder head in the ECT sensor 2 installation hole side, and install the thermostat for the cylinder block in the ECTsensor 4 installation hole side. 2) Install a new thermostat cover O-ring on the thermostat cover, and tighten the thermostat cover with the three 6 x 22 mm flange bolts securely. 3) Set the tube clamp D25.0 on the water relief tube A, and insert the water relief tube A into the thermostat cover securely. 4) Position the tube clamp D25.0 so that its lugs are toward the direction shown.

5) Install a new 9.5 x 1.9 mm O-ring on the ECT sensor 2 and 4 respectively. Apply a liquid sealant (ThreeBond ® #1201 or #1215 or equivalent) to the threads and seat of each sensor. 6) Install the ECT sensor 2 and 4, and tighten them to the specified torque. TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft) 7) Set the 18.5 mm clamp, harness band clip and the wire harness clip on the harness clip bracket B, and tighten the two 6 x 14 mm flange bolts. 8) Install the engine cover (P. 4-2). [1] THERMOSTAT COVER 6 x 22 (3) [3] WATER RELIEF TUBE A [2] TUBE CLAMP D25.0 [14] THERMOSTAT COVER O-RING Do not reuse. [4] HARNESS CLIP BRACKET B [13] THERMOSTAT (60˚C: For cylinder block) [12] ECT SENSOR 4 12 N .

m (1.2 kgf . m, 9 lbf . ft) 6 x 14 (2) [11] 9.5 x 1.9 mm O-RING (2) Do not reuse. [10] THERMOSTAT (50˚C: For cylinder head) [9] ECT SENSOR 2 [5] 18.5 mm CLAMP 12 N . m (1.2 kgf . m, 9 lbf . ft) [7] WIRE HARNESS CLIP [6] HARNESS BAND CLIP [8] BREATHER TUBE 8-4