b. INSPECTION • THERMOSTAT 1) Immerse the thermostat in water. 2) Heat the water and observe the operation of the thermostat as the water temperature increases. 3) Measure the water temperature when the thermostat starts to open. [1] THERMOMETER [2] THERMOSTAT Don't let the thermometer or the thermostat touch the container; this may cause a false reading. Thermostat for cylinder head: Thermostat for cylinder block: 4) Measure the lift height when the thermostat is fully open. Thermostat for cylinder head: Thermostat for cylinder block: c.
THERMOSTAT IDENTIFICATION [1] NOTICE [2] GROOVES (2 places) There are two types of thermostat; one for the cylinder head and the other for the cylinder block. Do not confuse them on assembly. Thermostat for cylinder head: The thermostat for the cylinder head can be identified with the purple paint (or two grooves) on the thermostat. [3] PURPLE PAINT Thermostat for cylinder block: The thermostat for the cylinder block can be identified with no paint (or three grooves) on the thermostat.
[1] [2] GROOVES (3 places) 8-3 Start opening 48 – 52˚C (118 – 126˚F) Fully open 60˚C (140 ˚F) Start opening 58 – 62˚C (136 – 144˚F) Fully open 70˚C (158˚F) Lift height More than 3.0 mm (0.12 in) Lift height More than 3.0 mm (0.12 in)