honda — Thermostat/Relief Valve/Flush Valve

b. INSPECTION • FLUSH VALVE Check the flush valve gasket for deterioration and cracks, and replace the flush valve if necessary. [1] FLUSH VALVE GASKET c. ASSEMBLY [2] FLUSH VALVE COVER SIDE Check each tube for deterioration and cracks before assembly. Replace the tubes if necessary. NOTICE 1) Install a new 16 mm O-ring on the flush valve cover. 2) Install the flush valve spring and the flush valve on the flush valve cover. Note the installation direction of the flush valve. 3) Tighten the flush valve cover with the 6 x 16 mm flange bolt securely. 4) Install the tube clip B12.5s, flush plug cap, water hose joint A and the water seal on the 8 x 300 mm tube.

Connect the 8 x 300 mm tube to the flush valve cover and clamp the tube with the tube clip B12.5s. 5) Connect the 7 x 200 mm tube to the mount case. 6) Install the following parts. – L./R. engine under covers (P. 4-14) – Engine cover (P. 4-2) [3] MOUNT CASE [2] 7 x 200 mm TUBE [1] TUBE CLAMP D10.5 (2) [4] FLUSH VALVE SPRING [5] FLUSH VALVE [12] 8 x 300 mm TUBE [6] 16 mm O-RING [7] FLUSH VALVE COVER 6 x 16 [11] FLUSH PLUG CAP [10] WATER HOSE JOINT A [9] WATER SEAL [8] 13 mm TUBE CLIP B1 (2) 8-11