honda — Thermostat/Relief Valve/Flush Valve

3. FLUSH VALVE a. DISASSEMBLY Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under cover (P. 4-9) 1) Disconnect the 7 x 200 mm tube from the mount case. 2) Disconnect the 8 x 300 mm tube from the flush valve cover. Remove the water seal, water hose joint A and the flush plug cap from the 8 x 300 mm tube. 3) Remove the 6 x 16 mm flange bolt, then remove the flush valve cover, flush valve and the flush valve spring. Do not reuse the 16 mm O-ring on the flush valve cover. Replace with a new one on assembly.

[1] TUBE CLAMP D10.5 (2) [3] MOUNT CASE [2] 7 x 200 mm TUBE [4] FLUSH VALVE SPRING [5] FLUSH VALVE [12] 8 x 300 mm TUBE [6] 16 mm O-RING [7] FLUSH VALVE COVER 6 x 16 [11] FLUSH PLUG CAP [10] WATER HOSE JOINT A [9] WATER SEAL [8] 13 mm TUBE CLIP B1 (2) 8-10