honda — Thermostat/Relief Valve/Flush Valve

6) Connect the 7 x 75 mm tube and the water tube E to the 4-way joint. 7) Connect the 7 x 75 mm tube to the fuel tube joint. 8) Connect the 7 x 90 mm tube and the 7 x 120 mm tube to the fuel tube joint. 9) Connect the 7 x 120 mm tube with the lugs of the tube clamp D10.5s toward down. g. INSTALLATION OF WATER RELIEF TUBE ASSEMBLY 1) Connect the water relief tube B to the exhaust guide. Clamp the water relief tube B with the water tube clamp B. 2) Connect the water relief tube A to the thermostat cover and set the tube clamp D25.0 with its lugs toward the direction shown (i.e. toward the intake manifold side). Clamp the water relief tube A and the main wire harness with the water tube clamp.

3) Connect the 7 x 90 mm tube and the water tube E to the engine side. 4) Connect the 7 x 120 mm tube to the engine side and set the tube clamp D10.5s with the lugs toward down. 5) Install the following parts. – L./R. engine under covers (P. 4-14) – Engine cover (P. 4-2) NOTICE Start the engine after connecting the tubes. Check that the water does not leak from each joint. [3] THERMOSTAT COVER [14] WATER RELIEF TUBE A [1] TUBE CLAMP D25.0 (4) [2] TUBE CLAMP D10.5 (8) [13] WATER TUBE CLAMP [12] 7 x 90 mm TUBE [11] FUEL TUBE JOINT [10] 7 x 75 mm TUBE [9] 4-WAY JOINT [8] 7 x 120 mm TUBE [7] WATER TUBE E [6] WATER RELIEF TUBE B [4] EXHAUST GUIDE [5] WATER TUBE CLAMP B 8-9