f. ASSEMBLY OF WATER RELIEF TUBE ASSEMBLY [1] WATER RELIEF TUBE A SIDE Check the tubes for deterioration and cracks before assembly. Replace if necessary. NOTICE 1) Note the connection position of each tube to the 4-way joint as shown. [2] 4-WAY JOINT 2) Connect the water relief tube B to the 4-way joint so that its installation angle is approximately 33˚ as shown. [3] WATER RELIEF TUBE B SIDE [4] 4-WAY JOINT [5] [6] WATER RELIEF TUBE B 3) Connect the water relief tube A to the 4-way joint so that its installation angle is approximately 90˚ as shown. [1] 4-WAY JOINT [3] APPROX. 90˚ [2] WATER RELIEF TUBE A 4) Set the tube clamp D25.0s on the water relief tube A and B.
[1] TUBE CLAMP D25.0 (2) [2] WATER RELIEF TUBE A 5) Set the tube clamp D25.0s in the position 8 mm from the end of each tube as shown. [3] 4-WAY JOINT 8 mm (0.3 in) [4] WATER RELIEF TUBE B 8-8 RO X. 33˚ 8 mm (0.3 in)