honda — Thermostat/Relief Valve/Flush Valve

e. WATER RELIEF TUBE C/RELIEF VALVE ASSEMBLY [1] RELIEF VALVE COVER SIDE NOTICE Check the tubes for deterioration and cracks before assembly. Replace if necessary. [2] RELIEF VALVE 1) Install the relief valve on the mount case noting the installation direction as shown. 2) Set a new relief valve cover O-ring on the relief valve cover, and install the relief valve cover with the two 6 x 22 mm flange bolts. 3) Connect the 7 x 160 mm tube, 7 x 40 mm tube and the water relief tube C to the T-joint, and clamp each tube with the tube clamp D10.5.

4) Set the tube clamp D10.5 on the side of each tube where is opposite to the other end connected to the T-joint, and connect each tube to the engine side. Clamp each tube with the tube clamp D10.5. [3] MOUNTING CASE SIDE [1] TUBE CLAMP D10.5 (6) [8] 7 x 160 mm TUBE 6 x 22 (2) [2] WATER RELIEF TUBE C [7] RELIEF VALVE COVER [6] T-JOINT [5] 7 x 40 mm TUBE [4] RELIEF VALVE COVER O-RING [3] RELIEF VALVE 8-7