honda — Crankshaft Pulley/Cam Chain

1. DISASSEMBLY [1] HARNESS CLIP BRACKET C 6 x 14 (3) Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under cover (P. 4-9) – Silencer duct (P. 6-2) – Alternator belt (P. 3-29) – Thermostat (P. 8-2) – Cylinder head cover (P. 10-2) Put the No.1 piston at the top dead center of its compression stroke before disassembly (P. 3-12 and 13). [2] HARNESS BAND CLIP (3) 1) Detach the A/F sensor 4P connector and the VTEC solenoid valve 1P connector [BF150A only] from the harness clip bracket C. Disconnect the connectors. 2) Remove the three harness band clips from the harness clip bracket C.

3) Remove the three 6 x 14 mm flange bolts from the harness clip bracket C and remove the harness clip bracket C. [4] A/F SENSOR 4P CONNECTOR [3] VTEC SOLENOID VALVE 1P CONNECTOR [BF150A only] 4) Remove the two 8 x 20 mm flange bolts from the engine hanger B and remove the engine hanger B. 8 x 20 (2) [1] ENGINE HANGER B 5) Remove the main wire harness from the recesses of the chain case. [2] MAIN WIRE HARNESS [3] RECESSES OF CHAIN CASE 9-2