2. ASSEMBLY [1] CHAIN CASE ASSEMBLY: 1) Apply soapy water to the outer surface of a new 43 x 58 x 7 mm oil seal. [2] (Apply grease to the lip.) Using the special tools, drive in the 43 x 58 x 7 mm oil seal until it seats on the chain case as shown. After installation, apply grease to the oil seal lip. TOOLS: Driver 07749-0010000 Attachment, 52 x 55 mm 07746-0010400 [3] OIL SEAL [4] DRIVER 07749-0010000 [5] ATTACHMENT, 52 x 55 mm 07746-0010400 [3] OIL SEAL 2) Remove the old liquid gasket, oil and contamination from the chain case cover and the chain case mating surfaces.
3) Apply a bead [ш2.0 – 3.0 mm (ш0.08 – 0.12 in)] of the liquid gasket (ThreeBond ® #1280B or equivalent) to the indicated area of the chain case cover. Assemble the chain case cover within 5 minutes after application of the liquid gasket. If it has been left for 5 minutes or longer, remove the old liquid gasket and apply the liquid gasket again before assembly. NOTICE [1] Apply a bead of liquid gasket as shown. 9-9