honda — Crankshaft Pulley/Cam Chain

8) Pushing the cam chain tensioner arm toward the cam chain, install the cam chain tensioner by aligning the cutouts of the cam chain tensioner with the recess in the cam chain tensioner arm. Tighten the two 6 x 30 mm flange bolts to the specified torque. 6 x 30 (2) [1] 1.5 mm PIN TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft) Remove the 1.5 mm pin. [2] CAM CHAIN TENSIONER [3] CAM CHAIN TENSIONER ARM [4] RECESS [5] CUTOUTS 9) Wipe up oil, etc. from the crankshaft outer surface with a clean shop towel. Install the crankshaft pulser plate on the crankshaft with the “OUT-SIDE” mark facing out. [1] “OUT-SIDE” MARK [2] CRANK PULSER PLATE [3] CRANKSHAFT (Wipe up oil, etc.

from crankshaft surface with a clean shop towel.) 9-13