honda — Crankshaft Pulley/Cam Chain

24) Position the main wire harness in the recesses of the chain case. 8 x 20 (2) [1] ENGINE HANGER B 25) Tighten the engine hanger B with the two 8 x 20 mm flange bolts. [2] MAIN WIRE HARNESS [3] RECESSES OF CHAIN CASE 26) Position the three harness band clips on the harness clip bracket C. Tighten the harness clip bracket C with the three 6 x 14 mm flange bolts securely. [1] HARNESS CLIP BRACKET C 6 x 14 (3) 27) Connect the A/F sensor 4P connector and the VTEC solenoid valve 1P connector [BF150A only], and install them on the harness clip bracket C. 28) Install the following parts. – Cylinder head cover (P. 10-40) – Thermostat (P. 8-4) – Alternator belt (P. 3-30) – Silencer duct (P.

6-4) – L./R. engine under cover (P. 4-14) – Engine cover (P. 4-2) [2] HARNESS BAND CLIP (3) [4] A/F SENSOR 4P CONNECTOR [3] VTEC SOLENOID VALVE 1P CONNECTOR [BF150A only] 9-19