3. CAMSHAFT/ROCKER ARM DISASSEMBLY Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) – Ignition coil/spark plug (P. 3-6) – Cylinder head cover (P. 10- 2) 1) Move the remote control lever to the “N” (Neutral) position. 2) Turn the crankshaft pulley clockwise until it sets the No.1 piston at the top dead center of its compression stroke (P. 3-12). Remove the following parts. – Crankshaft pulley/cam chain (P. 9-2) 3) Disconnect the CMP sensor 3P connector. Remove the harness band clip from the clip bracket F.
[1] CLIP BRACKET F [2] HARNESS BAND CLIP [3] CMP SENSOR 3P CONNECTOR 4) Remove the 6 x 16 mm flange bolts from the No.5 rocker shaft holder, then remove the CMP sensor and the CMP hole plug. 5) Remove the 15.2 x 1.9 mm O-rings from the CMP sensor and the CMP hole plug. Replace the O-rings with the new ones on assembly. [1] CMP HOLE PLUG [2] CMP SENSOR 6 x 16 (2) 6) Secure the hex. part of the intake camshaft with a wrench or equivalent tool. [1] INTAKE CAMSHAFT 10-5