7. CYLINDER HEAD ASSEMBLY INSPECTION • VALVE SPRING FREE LENGTH Measure the free length of the valve springs. • VALVE FACE/VALVE STEM O.D. Inspect each valve face for pitting or wear irregularities. Inspect each valve face for even seat. Replace the valve if necessary. 1) Check each valve for bend, seizure or damage. 2) Insert each valve into the corresponding valve guide to check the operation. 3) Measure the valve stem O.D. at the sliding surface of the valve guide. [1] VALVE FACE • VALVE LENGTH/VALVE O.D. [1] OVERALL LENGTH [2] VALVE O.D. • VALVE GUIDE I.D. Using the valve guide reamer, 5.525 mm (special tool), ream the valve guides to remove any carbon deposits before measuring.
Measure and record each valve guide I.D. [1] VALVE GUIDE REAMER, 5.525 mm 07HAH-PJ70100 NOTICE Turn the valve guide reamer, 5.525 mm (special tool) clockwise and never turn it counterclockwise. Continue to turn the reamer as you lift it from the valve guide. 10-23 STANDARD SERVICE LIMIT IN/EX 49.64 mm (1.954 in) STANDARD SERVICE LIMIT IN 5.475 – 5.485 mm (0.2156 – 0.2159 in) 5.445 mm (0.2144 in) EX 5.450 – 5.460 mm (0.2146 – 0.2150 in) 5.420 mm (0.2134 in) STANDARD SERVICE LIMIT OVERALL LENGTH IN 108.7 – 109.5 mm (4.28 – 4.31 in) EX 108.3 – 109.1 mm (4.26 – 4.30 in) VALVE O.D.
IN 34.85 – 35.15 mm (1.372 – 1.384 in) EX 29.85 – 30.15 mm (1.175 – 1.187 in) STANDARD SERVICE LIMIT IN/EX 5.51 – 5.53 mm (0.217 – 0.218 in) 5.55 mm (0.219 in)