honda — Cylinder Heads/Valves

8. VALVE GUIDE REPLACEMENT 1) Chill the replacement valve guides in the freezer section of a refrigerator for about an hour. [1] VALVE GUIDE DRIVER, 5.5 mm 07742-0010100 2) Drive the valve guide out of the combustion chamber side using a special tools. TOOL: Valve guide driver, 5.5 mm 07742-0010100 CAUTION When driving the valve guides out, be careful not to damage head. 3) Remove the new valve guides from the refrigerator one at a time as needed. [1] VALVE GUIDE 4) Install the new valve guides from the valve spring side of the cylinder head. Drive each valve guide as shown. [2] PROJECTION HEIGHT 5) After installation, inspect the valve guide for damage. Replace any damaged valve guide.

• VALVE GUIDE REAMING For best results, be sure the cylinder head is at room temperature before reaming valve guides. [1] VALVE GUIDE REAMER, 5.525 mm 07HAH-PJ70100 1) Coat the reamer and valve guide with cutting oil. 2) Rotate the reamer clockwise through the valve guide for the full length of the reamer. 3) Continue to rotate the reamer clockwise while removing it from the valve guide. TOOL: Valve guide reamer, 5.525 mm 07HAH-PJ70100 10-26 Valve guide projection height IN 15.2 – 16.2 mm (0.60 – 0.64 in) EX 15.5 – 16.5 mm (0.61 – 0.65 in)