honda — Cylinder Heads/Valves

• CYLINDER HEAD WARPAGE 1) Remove the carbon deposits from the combustion chamber. Clean off any gasket material from the cylinder head surface. [1] MEASUREMENT POINT 2) Check the spark plug holes and valve areas for cracks. 3) Check the cylinder head for warpage using a straight edge and a feeler gauge. NOTICE [2] STRAIGHT EDGE Take care not to damage (scores, scratches, etc.) the cylinder head at the mating surface with the gasket. 4) If the measurement exceeds the service limit, recondition. Reconditioning must be made within the standard value of the cylinder head height. NOTICE [3] FEELER GAUGE • CYLINDER HEAD HEIGHT [1] CYLINDER HEAD HEIGHT Cylinder head reconditioning procedure:

Apply Prussian Blue compound to the level block to identify the warpage, and using a fine oil stone, grind the cylinder head in the figure of “8” with the warped part being the center of the ground part. Or use the lapping machine to recondition the cylinder head. • 11 x 155 mm BOLT-WASHER (CYLINDER HEAD BOLT) O.D. 1) Measure the bolt O.D. at two points as shown. 50 mm (2.0 in) SERVICE LIMIT 10.6 mm (0.42 in) 2) If the measurement is below the service limit, replace the bolt. 45 mm (1.8 in) 10-25 SERVICE LIMIT 0.05 mm (0.002 in) Min. STANDARD SERVICE LIMIT 103.95 – 104.05 mm (4.093 – 4.096 in)