honda — Cylinder Heads/Valves

9. VALVE SEAT RECONDITIONING 1) Thoroughly clean the combustion chambers and valve seats to remove carbon deposits. Apply a light coat of Prussian Blue compound or erasable felt-tipped marker ink to the valve faces. 2) Insert the valves, and then lift them and snap them closed against their seats several times. Be sure the valve does not rotate on the seat. The transfered marking compound will show any area of the seat that is not concentric. [1] VALVE FACE 3) Using a 45˚ cutter, remove enough material to produce a smooth and concentric seat. Follow the Valve Seat Cutter Manufacturer's Instructions. [1] VALVE SEAT CUTER Turn the cutter clockwise, never counterclockwise.

Continue to turn the cutter as you lift it from the valve seat. [2] IN, 35 mm: 07780-0010400 EX, 33 mm: 07780-0010800 TOOLS: Cutter holder, 5.5 mm 07781-0010101 Valve seat cutter, 45˚ 35 mm 07780-0010400 Valve seat cutter, 45˚ 33 mm 07780-0010800 Valve seat cutter, 32˚ 38.5 mm 07780-0012400 Valve seat cutter, 32˚ 33 mm 07780-0012900 Valve seat cutter, 60˚ 30 mm 07780-0014000 Valve seat cutter, 60˚ 37.5 mm 07780-0014100 [3] IN, 37.5 mm: 07780-0014100 EX, 30 mm: 07780-0014000 [4] IN, 38.5 mm: 07780-0012400 EX, 33 mm: 07780-0012900 [5] CUTTER HOLDER, 5.5 mm 07781-0010101 4) Use the 30˚ – 32˚ and 60˚ cutters to narrow and adjust the valve seat so that it contacts the middle of the valve face.

The 30˚ – 32˚ cutter removes material from the top edge. The 60˚ cutter removes material from the bottom edge. Be sure that the width of the finished valve seat is within specification. [2] OLD SEAT WIDTH [1] CONTACT TOO HIGH [2] OLD SEAT WIDTH [3] CONTACT TOO LOW 10-28