honda — Cylinder Heads/Valves

• VALVE SEAT WIDTH 5) Make a light pass with the 45˚ cutter to remove any possible burrs at the edges of the seat. 1.25 – 1.55 mm (0.049 – 0.061 in) 6) After resurfacing the seats, inspect for even valve seating. Apply Prussian Blue compound or erasable felt-tipped marker ink to the valve faces. Insert the valves, and then lift them and snap them closed against their seats several times. Be sure the valve does not rotate on teh seat. The seating surface, as shown by the transferred marking compound, should have good contact all the way around. 7) Lap the valves into their seats, using a hand valve lapper and lapping compound (commercially available).

[1] VALVE LAPPER (Commercially available) To avoid severe engine damage, be sure to remove all lapping compound from the cylinder head before assembly. NOTICE 8) Check valve clearance after assembly. 10-29 STANDARD SERVICE LIMIT IN/EX 1.25 – 1.55 mm (0.049 – 0.061 in) 2.0 mm (0.08 in)