12. CAMSHAFT/ROCKER ARM ASSEMBLY [1] Apply a bead of the liquid gasket. 1) Degrease the cylinder head mating surface of the No.5 rocker shaft holder with the degreasing cleaning agent. 2) Apply a bead [ш2.0 – 3.0 mm (ш0.08 – 0.12 in)] of the liquid gasket (ThreeBond ® #1280B or equivalent) to the indicated area of the No.5 rocker shaft holder. NOTICE Assemble the No.5 rocker shaft holder within 5 minutes after application of the liquid gasket. If it has been left for 5 minutes or longer, remove the old liquid gasket and apply the liquid gasket again. Do not pour the engine oil in the oil tank at least 30 minutes after assembly.
[1] ROCKER ARM ASSEMBLY 3) Set the ten dowel pins on the cylinder head assembly. 4) Insert the bolts into each of the rocker shaft holders and install the rocker arm assembly on the cylinder head assembly. [3] 10 x 16 mm DOWEL PIN (10) [2] BOLT (4) 5) Apply engine oil to the threads and seat of the 14 mm sealing bolts. Install the camshaft collar on the intake camshaft and the CMP pulse plate on the exhaust camshaft, then tighten the 14 mm sealing bolts to the specified torque. [2] EXHAUST CAMSHAFT [1] CAMSHAFT COLLAR [3] CMP PULSE PLATE TORQUE: 39 N . m (4.0 kgf . m, 29 lbf . ft) NOTICE Tighten the bolt while holding the hex. part of the camshaft with a wrench or equivalent tool.
Do not damage (scores, scratches, etc.) the cams and journals of the camshaft journal. [5] INTAKE CAMSHAFT [4] 14 mm SEALING BOLT (2) 10-34