6) Apply molybdenum disulfide oil to the journals and cam surfaces of the camshafts. 7) Install the intake/exhaust camshafts, ten dowel pins, camshaft holders and the cam chain guide B. Install the camshafts with the No.1 piston at the top dead center of the compression stroke (i.e. dowel pin at your side). NOTICE 8) Apply engine oil to the threads and seat of each bolt and loosely tighten to the designated position respectively.
[1] INTAKE CAMSHAFT [2] EXHAUST CAMSHAFT [3] CAM CHAIN GUIDE B 8 x 110 (2) [4] HEAD COVER BOLT (6) 8 x 90 (12) 6 x 20 (2) [6] 10 x 16 mm DOWEL PIN (10) 6 x 32 [7] MOLYBDENUM DISULFIDE OIL [5] CAMSHAFT HOLDER 9) Tighten each bolt to the specified torque in the numbered sequence in two or three steps. u i p o TORQUE: Head cover bolt, 8 x 90 mm flange bolt, 8 x 110 mm flange bolt: 22 N . m (2.2 kgf . m, 16 lbf . ft) 6 x 20 mm flange bolt, 6 x 32 mm flange bolt: 12 N . m (1.2 kgf . m, 9 lbf . ft) w q 9 0 a 1 2 4 3 5 6 8 7 s d y t e r 10-35