14. CYLINDER HEAD COVER INSTALLATION 1) Thoroughly clean the cylinder head/cylinder head cover mating surfaces using a degreasing cleaning agent. 2) Apply a bead [ш2.0 – 3.0 mm (ш0.08 – 0.12 in)] of the liquid gasket (ThreeBond ® #1280B or equivalent) to the cylinder head/chain case mating surfaces and to the No.5 rocker shaft holder as shown. [1] Apply a bead of liquid gasket. Assemble the cylinder head cover within 5 minutes after application of the liquid gasket. If it has been left for 5 minutes or longer, remove the old liquid gasket and apply the liquid gasket again. Do not pour the engine oil in the oil tank at least 30 minutes after assembly.
NOTICE 3) Apply soapy water to the spark plug tube seal lip of the cylinder head cover. [1] Apply soapy water to the lip. 4) Install the cylinder head cover on the cylinder head by aligning the spark plug tube with the spark plug tube seal. NOTICE [2] SPARK PLUG TUBE SEAL (4) Check the spark plug tube seals for breakage and fatigue when installing the cylinder head cover. After installation, check that the spark plug tube seals are not turned up but they are set properly. Wipe up the oozing soapy water. 5) After installation, swing the cylinder head cover lightly to make the head cover gasket fit on the cylinder head cover.
6) Install the six head cover washers and loosely tighten the six 6 mm hex. cap nuts. [3] SPARK PLUG TUBE (4) [4] CYLINDER HEAD COVER [5] HEAD COVER WASHER (6) [6] 6 mm HEX. CAP NUT (6) 10-40