1. EOP SWITCH/OIL FILTER FLANGE a. DISASSEMBLY Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under covers (P. 4-9) 1) Drain the engine oil (P. 3-2) and remove the oil filter using the special tool as shown. TOOL: Oil filter wrench 07HAA-PJ70101 2) Remove the EOP switch (low pressure side). 3) Disconnect the water tube E and 7 x 160 mm tube from the oil filter flange. 4) Remove the oil filter flange. 5) Disconnect the ECT sensor 2P connector and the EOP switch (high pressure side) 2P connector. Remove the ECT sensor and the EOP switch (high pressure side). [1] OIL FILTER WRENCH 07HAA-PJ70101 [3] ECT SENSOR [2] 9.5 x 1.9 mm O-RING 12 N . m (1.2 kgf . m, 9 lbf .
ft) [4] TUBE CLAMP D10.5 (2) [1] 13 x 1.5 mm O-RING Do not reuse. Do not reuse. [5] EOP SWITCH (LOW PRESSURE SIDE) 8 N . m (0.8 kgf . m, 5.8 lbf . ft) 6 x 25 (4) [6] OIL FILTER 12 N . m (1.2 kgf . m, 9 lbf . ft) [7] OIL FILTER FLANGE [11] EOP SWITCH (HIGH PRESSURE SIDE) 6 x 20 22 N . m (2.2 kgf . m, 16 lbf . ft) [10] WATER TUBE E [8] 7 x 160 mm TUBE INSPECTION: Check the tube for deterioration. Replace the tube if necessary. [9] 22.5 x 24 mm O-RING (2) INSPECTION: Check the tube for deterioration. Replace the tube if necessary. Do not reuse. 11-2