b. INSPECTION Check for continuity between the terminal and body. If there is no continuity, replace the EOP switch c. ASSEMBLY 1) Apply engine oil to a new 13 x 1.5 mm O-ring and install it on the ECT sensor. 2) Tighten the ECT sensor to the specified torque and connect the ECT sensor 2P connector. [2] ECT SENSOR [1] 9.5 x 1.9 mm O-RING TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft) 3) Apply engine oil to the 9.5 x 1.9 mm O-ring and install it on the EOP switch (high pressure side). 4) Tighten the EOP switch (high pressure side) to the specified torque and connect the EOP switch (high pressure side) 2P connector. TORQUE: 22 N . m (2.2 kgf . m, 16 lbf .
ft) [4] 13 x 1.5 mm O-RING [3] EOP SWITCH (High pressure side) 11-3