honda — Oil Pump/Flywheel

d. ASSEMBLY 1) Apply thread locking agent to the threads of the 18 mm sealing bolt. [1] OIL PUMP BODY 2) Check the relief valve surface for scores, scratches and other damage. Apply engine oil to the relief valve and the relief valve spring. 3) Install the relief valve and the relief valve spring in the oil pump body, and tighten the 18 mm sealing bolt to the specified torque. TORQUE: 39 N . m (4.0 kgf . m, 29 lbf . ft) [4] RELIEF VALVE [3] RELIEF VALVE SPRING [2] 18 mm SEALING BOLT 4) Clean the inner rotor and the outer rotor thoroughly. Apply engine oil to the inner and outer rotors and install them on the oil pump body.

Note to install the rotors in the same direction as the direction of the rotors noted on disassembly. [2] INNER ROTOR [3] OUTER ROTOR [1] OIL PUMP BODY 5) Install the two dowel pins and the oil pump cover on the oil pump body and tighten the nine 6 x 16 mm flat screws. Check that the rotors move smoothly. [2] 6 x 16 mm FLAT SCREW (9) [1] OIL PUMP COVER [4] 5 x 8 mm DOWEL PIN (2) [3] OIL PUMP BODY 11-10