6) Apply soapy water to the outer surface of each new oil seal. 7) Using the special tools, drive the 46 x 60 x 9 mm oil seal into the oil pump body and the 31 x 46 x 7 mm oil seal into the oil pump cover so they set in the respective position of the dimensions shown. – Install the 46 x 60 x 9 mm oil seal so that the distance from the oil pump body end to the oil seal surface is 27.4 – 28.0 mm (1.08 – 1.10 in) (dimension A). – Install the 31 x 46 x 7 mm oil seal so that the distance from the oil pump body end to the oil seal surface is 63.9 – 64.5 mm (2.52 – 2.54 in) (dimension B) with the oil pump cover installed with the flat screws. TOOLS:
Driver 07749-0010000 Oil seal driver attachment, 72 mm 07947-6340201 Oil seal driver 07947-SB00100 8) After installing the oil seals, apply grease to each oil seal lip. [1] 46 x 60 x 9 mm OIL SEAL [2] direction> [2] direction> [5] 31 x 46 x 7 mm OIL SEAL [3] (Apply grease to the lip.) [3] (Apply grease to the lip.) [4] DRIVER 07749-0010000 [9] OIL SEAL DRIVER ATTACHMENT, 72 mm 07947-6340201 [4] DRIVER 07749-0010000 [8] OIL PUMP BODY [6] OIL PUMP COVER [7] OIL SEAL DRIVER 07947-SB00100 [10] DIMENSION B [11] DIMENSION A e. INSTALLATION 1) Install the 14 x 20 mm dowel pin, 10 x 16 mm dowel pin, and the new oil pump body gasket on the engine side.
Install the oil pump body and tighten the five 8 x 32 mm flange bolts. [1] OIL PUMP BODY ASSEMBLY [2] 14 x 20 mm DOWEL PIN 2) Install the engine on the outboard motor (P. 7-6). [3] 10 x 16 mm DOWEL PIN [4] OIL PUMP BODY GASKET 8 x 32 (5) 11-11