honda — Oil Pump/Flywheel

3. FLYWHEEL a. REMOVAL 1) Remove the engine from the outboard motor (P. 7-2). 2) Remove the oil pump body assembly (P. 11-6). 3) Set the special tool on the starter motor mounting part and temporarily tighten the special tool using the 10 mm bolts, 10 mm washers and the 10 mm nuts. [1] 10 mm BOLT (2) NOTICE Do not damage the mating surface of the oil pump body gasket on the cylinder block. Check that the special tool is set on the ring gear securely. [2] RING GEAR HOLDER 070PB-ZY60100 [3] 10 mm NUT (2) TOOL: Ring gear holder 070PB-ZY60100 4) Remove the eight 8 mm special bolts and the flywheel boss. [1] FLYWHEEL BOSS [2] 8 mm SPECIAL BOLT (8) 5) Remove the eight 12 mm bolts and the flywheel.

6) Remove the special tool. [1] 12 mm BOLT (8) [2] FLYWHEEL 11-12