honda — Crankcase/Balancer

3. INSPECTION • BALANCER SHAFT JOURNAL O.D. Measure the O.D. of the balancer shaft No.1 journal. If the measurement exceeds the service limit, replace the balancer shaft. • BALANCER SHAFT AXIAL FREE PLAY 1) Assemble the balancer case assembly (P. 12-7). 2) Measure the balancer shaft axial play with the dial indicator by moving the balancer shaft back and force. 3) If the measurement exceeds the service limit, replace the balancer case assembly. • BALANCER SHAFT OIL CLEARANCE 1) Clean the balancer shaft No.2 journal and the balancer holder bearing. Check the journal and the bearing for damage and wear. 2) Assemble the balancer case assembly (P. 12-7). 3) Remove the rear balancer holder.

Set a plastigauge on the balancer shaft No.2 journal as shown. [1] PLASTIGAUGE NOTICE Set the plastigauge in the axial direction on the balancer shaft No.2 journal. Do not turn the balancer shaft while checking oil clearance. 4) Reinstall the rear balancer holder and tighten the bolts to the specified torque (P. 12-7). 5) Remove the rear balancer holder. Measure the width of the pressed part of the plastigauge using the scale printed on the bag of the plastigauge. [1] PLASTIGAUGE NOTICE Measure the widest width on the plastigauge. 6) If the measurement exceeds the service limit, replace the balancer shaft bearing and recheck the oil clearance.

If the measurement still exceeds the service limit, replace the balancer shaft. [2] SCALE 12-6 STANDARD SERVICE LIMIT Front 19.938 – 19.950 mm (0.7850 – 0.7854 in) 19.92 mm (0.784 in) Rear 23.938 – 23.950 mm (0.9424 – 0.9429 in) 23.92 mm (0.942 in) STANDARD SERVICE LIMIT 0.060 – 0.140 mm (0.0024 – 0.0055 in) 0.15 mm (0.006 in) STANDARD SERVICE LIMIT 0.060 – 0.120 mm (0.0024 – 0.0047 in) 0.15 mm (0.006 in)