4. BALANCER CASE ASSEMBLY ASSEMBLY [1] BALANCER SHAFT BEARING [2] PROJECTION 1) Install the four balancer shaft bearings on the front/rear balancer holders by aligning the projection on each balancer shaft bearing with the concave at the corresponding bearing installation part of the front/rear balancer shaft. [3] CONCAVE 2) Apply molybdenum disulfide oil to each journal of the balancer shaft. [2] REAR BALANCER SHAFT 3) Install the front and rear balancer shafts on the front balancer holder while aligning the alignment marks on each of the front and rear balancer shaft gears as shown.
[1] FRONT BALANCER SHAFT [3] MOLYBDENUM DISULFIDE OIL [4] ALIGNMENT MARKS [5] FRONT BALANCER HOLDER 4) Apply engine oil to the threads and seat of the 8 x 55 mm flange bolts. [1] REAR BALANCER HOLDER 6 x 32 (3) 8 x 55 (3) 5) Install the four dowel pins and the rear balancer holder on the front balancer holder. Tighten the bolts to the specified torque. 6 x 25 (2) TORQUE: 8 x 55 mm flange bolt: 27 N . m (2.8 kgf . m, 20 lbf . ft) 6 x 32 mm flange bolt, 6 x 25 mm flange bolt: 12 N . m (1.2 kgf . m, 9 lbf . ft) [2] 12 x 16 mm DOWEL PIN (2) [3] 8 x 10 mm DOWEL PIN (2) 12-7