honda — Crankcase/Balancer

5. CRANKCASE/BALANCER CASE ASSEMBLY INSTALLATION 10 x 105 (2) 8 x 50 8 x 75 1) Apply engine oil to the threads and seat of each bolt. [1] BALANCER CASE ASSEMBLY 2) Install the balancer case assembly and the two dowel pins on the lower block and tighten the bolts to the specified torque. TORQUE: 10 x 105 mm flange bolt: 44 N . m (4.5 kgf . m, 33 lbf . ft) 8 x 75 mm flange bolt, 8 x 50 mm flange bolt: 22 N . m (2.2 kgf . m, 16 lbf . ft) [2] 18 x 13 mm DOWEL PIN [3] 12 x 16 mm DOWEL PIN 3) Install the crankshaft sprocket on the crankshaft aligning the projection on the crankshaft sprocket with the concave in the crankshaft.

After installation, check that the “ ” mark on the crankshaft sprocket aligns with the “ ” mark on the cylinder block. [1] CRANKSHAFT SPROCKET [2] CRANKSHAFT NOTICE The No.1 piston is at the top dead center of its compression stroke when the “ ” mark on the crankshaft sprocket aligns with the “ ” mark on the cylinder block. [4] PROJECTION [3] CONCAVE [5] ” MARK 12-8