honda — Crankcase/Balancer

16) Apply engine oil to the threads and seat of the 6 x 25 mm flange bolts 6 x 25 (18) 17) Install the two dowel pins and crankcase on the lower block and loosely tighten the 6 x 25 mm flange bolts. [1] CRANKCASE [2] 13 x 20 mm DOWEL PIN (2) 18) Tighten the 6 x 25 mm flange bolts to the specified torque in the numbered sequence in two to three steps. TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft) ⑫ ⑬ ⑭ 19) Install the engine on the outboard motor (P. 7-6). 20) Install the following parts. – Crankshaft pulley (P. 9-17) – Electric parts/main wire harness (P. 18-14, 17, 19 and 27) – Silencer duct (P. 6-4) – Throttle body/intake manifold (P. 5-132) – Silencer case (P. 5-135) – L./R.

engine under covers (P. 4-14) – Engine cover (P. 4-2) ⑧ ⑨ ⑤ ④ ① ② ③ ⑥ ⑦ ⑪ ⑩ ⑱ ⑰ ⑮ ⑯ 12-12