After replacing the balancer chain tensioner with new one: 11) Install the set clip, that came together with the new balancer chain tensioner, on the balancer chain tensioner. [1] BALANCER CHAIN TENSIONER [2] SET CLIP 12) Install the balancer chain tensioner assembled in step 10 on the rear balancer holder and tighten the three 6 x 14 mm flange bolts. After installation, remove the set clip from the balancer chain tensioner. [1] BALANCER CHAIN TENSIONER 6 x 14 (3) 13) Install the crankshaft pulley/cam chain (P. 9-11). Do not apply the liquid gasket to the chain case and crankcase mating surfaces.
Do not tighten the three bolts of the chain case/crankcase mating side and do not install the crankshaft pulley. NOTICE 14) Clean the crankcase and lower block mating surfaces thoroughly with the degreasing cleaning agent. 15) Apply a bead [ш2.0 – 3.0 mm (ш0.08 – 0.12 in)] of the liquid gasket (ThreeBond ® #1280B or equivalent) to the indicated area of the crankcase. [1] Apply a bead of liquid gasket. NOTICE Assemble the crankcase within 5 minutes after applying the liquid gasket. If it has been left for 5 minutes or longer, remove the old liquid gasket and apply the liquid gasket again. Do not pour the engine oil in the oil tank at least 30 minutes after assembly. 12-11