honda — Crankcase/Balancer

8) Install the driven sprocket together with the balancer chain on the rear balancer shaft by aligning the concave in the driven sprocket with the projection on the rear balancer shaft. [2] CONCAVE [3] PROJECTION [1] 10 x 30 mm BOLT-WASHER TORQUE: 44 N . m (4.5 kgf . m, 33 lbf . ft) After installation, remove the special tool from the balancer case assembly. [5] DRIVEN SPROCKET [4] REAR BALANCER SHAFT 9) Install the balancer chain guide on the lower block and tighten the two chain guide bolts to the specified torque. TORQUE: 12 N . m (1.2 kgf . m, 9 lbf .

ft) [1] CHAIN GUIDE BOLT (2) [2] BALANCER CHAIN GUIDE 10) Pushing the balancer chain tensioner against the balancer chain, install the balancer chain tensioner on the balancer holder. Tighten the three 6 x 14 mm flange bolts. [1] BALANCER CHAIN TENSIONER 6 x 14 (3) 12-10