honda — Cylinder Block/Crankshaft/Pistons

b. PISTON ASSEMBLY 1) Remove the connecting rod bearing and the piston ring from the piston assembly. Do not apply excessive force to the piston ring as it can break the piston ring. Handle the piston ring with care. Store the removed connecting rod bearing and the piston ring separately for each piston. NOTICE 2) Apply oil to the piston pin clip. Align the piston pin clip end gap with the cutout in the piston pin hole. NOTICE Do not damage the piston pin clip installation groove. 3) Remove the piston pin clips from the cut out at both sides of the piston. [1] PISTON PIN CLIP Remove the piston pin clips with care not to let them jump out of position.

NOTICE 4) Warm up the piston assembly to approximately 70˚C (158˚F) and remove the piston pin. CAUTION Take care not to get your hand, etc. burned during disassembly. 13-5 [1] [2] CONNECTING PISTON RING ROD BEARING [3] PISTON RING PLIERS (Commercially available) [1] PISTON PIN CLIP [2] CUTOUT