12) Remove the crankshaft from the cylinder block with care not to damage (scores, scratches, etc.) the journals. Remove the two thrust washers. [1] CRANKSHAFT 13) Before removing the upper main bearings, check each bearing for damage (scores, scratches, etc.) and replace if necessary. [2] UPPER MAIN BEARING (5) 14) Remove the five upper main bearings from the cylinder block. [3] THRUTST WASHER (2) NOTICE Store the upper main bearings separately for each journal. 15) Remove the oil jet orifice and the 6.5 x 1.5 mm O-ring from the cylinder block, and check the oil jet orifice for blockage.
If it is clogged, clean it with a cleaning solvent and remove the blockage by blowing the oil passage with the compressed air. If the blockage cannot be removed by blowing with the compressed air, replace the oil jet orifice with a new one. NOTICE Remove the blockage with care not to damage the oil passage of the oil jet orifice. [5] OIL JET ORIFICE [4] 6.5 x 1.5 mm O-RING 16) Remove the oil jet bolt from the No.1/No.2 cylinder of the cylinder block and remove the oil jet body. [1] OIL JET BOLT [2] OIL JET BODY 17) Remove the piston assembly from the cylinder by pushing the piston assembly with the handle of a hammer as shown.
[2] CYLINDER BLOCK [1] PISTON ASSEMBLY Before removing the piston assembly, remove the carbon deposits from the cylinder with care not to damage (scores, scratches, etc.) the piston. Do not damage the cylinder with the connecting rod. Store the removed piston assembly components separately for each cylinder. NOTICE 13-4