6) Remove the lower block, 80 x 98 x 10 mm oil seal and the eleven dowel pins from the cylinder block. Replace the oil seal on assembly. [1] LOWER BLOCK [2] 80 x 98 x 10 mm OIL SEAL [4] 13 x 14 mm DOWEL PIN (10) [3] 18 x 22 mm DOWEL PIN 7) Check the lower main bearings for damage (scores, scratches, etc.) and replace if necessary. 8) Remove the five lower main bearings from the lower block. [1] LOWER BLOCK ORIFICE Store the removed lower main bearings separately for each journal. NOTICE 9) Remove the lower block orifice from the lower block and check the lower block orifice for blockage.
If it is clogged, clean it with a cleaning solvent and remove the blockage by blowing the oil passage with the compressed air. If the blockage cannot be removed by blowing with the compressed air, replace the lower block orifice with a new one. [2] LOWER BLOCK [3] LOWER MAIN BEARING (5) NOTICE Remove the blockage with care not to damage the oil passage of the lower block orifice. 10) Check that the piston is at the bottom dead center of its stroke. If not, move the piston to the bottom dead center by turning the crankshaft. [1] CONNECTING ROD CAP [2] CONNECTING ROD BOLT (2) 11) Remove the connecting rod bolts, then remove the connecting rod cap, connecting rod bearing and the two dowel pins.
[3] CONNECTING ROD BEARING [4] 10 x 12 mm DOWEL PIN (2) Store the removed connecting rod cap, connecting rod bearing and the dowel pins classifying them into each cylinder. NOTICE 13-3