honda — Cylinder Block/Crankshaft/Pistons

2. INSPECTION • PISTON SKIRT O.D. 1) Check the piston outer surface for damage (scores, scratches, etc.). Check the piston for warpage and cracks. [1] O.D. 11 mm (0.4 in) 2) Measure and record the piston O.D. at a point 11 mm from the bottom, and 90˚ to the piston pin bore. • CYLNDER SLEEVE I.D. 1) Check the inner wall of the cylinder for damage (scores, scratches, etc.). [1] TOP 2) Measure and record the cylinder I.D. at three levels in both X and Y axis. Take the maximum reading to determine the cylinder I.D. [2] MIDDLE [3] BOTTOM [5] NO.1 CYLINDER [4] NO.4 CYLINDER • PISTON-TO-CYLINDER CLEARANCE [1] TOP X Y • CYLINDER SLEEVE I.D.

GAP BETWEEN TOP AND BOTTOM Determine the gap of the cylinder sleeve I.D. between the top and the bottom measurements. [2] MIDDLE [3] BOTTOM 13-8 STANDARD SERVICE LIMIT A 86.98 – 86.99 mm (3.4244 – 3.4248 in) 86.93 mm (3.4224 in) B 86.97 – 86.98 mm (3.4240 – 3.4244 in) 86.92 mm (3.4220 in) STANDARD SERVICE LIMIT A or l 87.01 – 87.02 mm (3.4256 – 3.4260 in) 87.07 mm (3.4279 in) B or ll 87.00 – 87.01 mm (3.4252 – 3.4256 in) 87.07 mm (3.4279 in) STANDARD SERVICE LIMIT 0.02 – 0.04 mm (0.001 – 0.002 in) 0.05 mm (0.002 in) SERVICE LIMIT 0.05 mm (0.002 in)