• PISTON RING THICKNESS 1) Check the piston ring for damage (scores, scratches, etc.). 2) Measure the piston ring thickness. The oil rings are the combination rings. Replace the top ring, second ring and the oil rings as a set when either top or second ring needs replacement. • PISTON RING GROOVE WIDTH 1) Check the piston ring grooves for uneven wear, damage and clogged oil hole. 2) Measure the piston ring groove width. [1] TOP [2] SECOND [3] OIL • PISTON RING SIDE CLEARANCE Set the piston ring on the piston properly so it is almost flush with the piston outer surface. Measure the piston ring side clearance. The oil rings are the combination rings.
Replace the top ring, second ring and the oil rings as a set when either top or second ring needs replacement. • PISTON RING END GAP Use the piston to push the piston ring into the cylinder and position it horizontally at 15 to 20 mm from the bottom of the cylinder. [1] PISTON RING OIL 0.20 – 0.70 mm 0.8 mm (0.008 – 0.028 in) (0.031 in) If the end gap is larger than the service limit, install a new piston ring and recheck. Check the cylinder sleeve I.D. (P. 13-8).
[2] END GAP 15 – 20 mm (0.6 – 0.8 in) 13-9 STANDARD SERVICE LIMIT TOP 1.170 – 1.185 mm (0.0461 – 0.0467 in) SECOND 1.175 – 1.190 mm (0.0463 – 0.0469 in) STANDARD SERVICE LIMIT TOP 1.23 – 1.24 mm (0.0484 – 0.0488 in) 1.25 mm (0.0492 in) SECOND 1.24 – 1.25 mm (0.0488 – 0.0492 in) 1.25 mm (0.0492 in) OIL 2.005 – 2.025 mm (0.0789 – 0.0797 in) 2.05 mm (0.081 in) STANDARD SERVICE LIMIT TOP 0.045 – 0.070 mm (0.0018 – 0.0028 in) 0.13 mm (0.005 in) SECOND 0.040 – 0.065 mm (0.0016 – 0.0026 in) 0.13 mm (0.005 in) STANDARD SERVICE LIMIT TOP 0.20 – 0.35 mm (0.008 – 0.014 in) 0.6 mm (0.02 in) SECOND 0.50 – 0.65 mm (0.020 – 0.026 in) 0.75 mm (0.030 in)