honda — Cylinder Block/Crankshaft/Pistons

22) Apply soapy water to the outer surface of the new 80 x 98 x 10 mm oil seal. Apply engine oil to the oil seal lip. 23) Using the special tools as shown, install the 80 x 98 x 10 mm oil seal on the crankshaft. Drive in the oil seal so its upper side is 0.2 – 1.2 mm (0.01 – 0.05 in) deep from the surface. [1] TOOLS: Driver 07749-0010000 Oil seal driver attachment, 96 07ZAD-PNA0100 NOTICE Drive in the oil seal with the part number on the oil seal toward out. 24) Install the following pars. – Crankcase/balancer case assembly (P. 12-8) – Flywheel (P. 11-14) – Oil pump (P. 11-11) – Engine assembly (P. 7-6) – Cylinder head assembly (P. 10-32) – L./R. engine under covers (P.

4-14) – Engine cover (P. 4-2) [3] OIL SEAL INSTALLATION DEPTH: [4] CRANKSHAFT 0.2 – 1.2 mm (0.01 – 0.05 in) [5] 80 x 98 x 10 mm OIL SEAL 13-26 [2] OIL SEAL DRIVER ATTACHMENT,96 07ZAD-PNA0100 ER 9-0010000 [2] OIL SEAL DRIVER ATTACHMENT,96 07ZAD-PNA0100